Skip to content

Most Pool Leaks Come From One Small Part

The Pool Guy Podcast Show

19m
Transcript

Original podcast

Where to listen

Summary

Written by a model from the transcript; not yet reviewed.

This episode covers the most common sources of water leaks in swimming pool equipment, offering a practical breakdown for identifying and fixing leaks around pumps, filters, valves, and heaters. The host explains that a significant percentage of equipment leaks stem from minor failures like worn-out O-rings, drain plugs, or seal plates rather than major structural damage. The discussion walks through diagnosing specific drips, distinguishing between irrigation issues and actual pool leaks, and applying quick fixes such as RV-grade silicone spray or temporary ball valves.

  • Check for nearby irrigation lines before spending hours searching for a mysterious pool equipment leak. 2:37
  • Replace the front pump drain plug O-ring when dealing with a minor drip right by the pump. 3:37
  • Thoroughly coat filter tank O-rings with RV-grade silicone spray to prevent recurring post-cleaning drip leaks. 10:01
  • Install a temporary ball valve on the backwash discharge line to stop low-pressure leaks without major replumbing. 15:59
  • Inspect O-rings first when troubleshooting equipment leaks, as they account for the vast majority of issues. 18:22

Chapters

  1. 0:00
    Episode Introduction and Sponsorship

    Hosts open the show and announce sponsors Hasa and Skimmer.

  2. 1:07
    Overview of Leak Topics

    The host outlines the episode’s focus on identifying and fixing pool leaks.

  3. 1:46
    Identifying Equipment Leaks

    Techniques for locating leaks around pool equipment are explained.

  4. 3:37
    Pump Leak Sources

    Common pump leak points such as drain plugs and seal plates are discussed.

  5. 5:03
    Motor and Seal Plate Leaks

    How to detect leaks from the motor side and seal plate failures is covered.

  6. 6:36
    Outlet and Inlet Leak Identification

    Differentiating between outlet and inlet pump leaks and their symptoms.

  7. 7:43
    Valve and Sensor Leak Sources

    Leaks from valves, temp sensors, and Jandy components are examined.

  8. 9:27
    Filter Leak Troubleshooting

    Common filter leaks, O-ring issues, and crack detection are detailed.

  9. 14:23
    Backwash Piston Leak Solutions

    Strategies for fixing backwash piston and multi-port valve leaks are presented.

  10. 16:46
    Heater Leak Points

    Potential heater leak locations and remedies are discussed.

  11. 18:28
    Closing Remarks and Resources

    The host summarizes key takeaways and directs listeners to coaching and resources.

Highlights

  • 2:37

    Irrigation Leak Confusionstory

    A persistent puddle under running pool equipment might not be a pool leak at all, but rather a nearby broken sprinkler head.

  • 3:37

    Front Pump Dripsinsight

    Water dripping directly at the front of the pump is usually caused by a worn-out wet end drain plug O-ring.

  • 5:03

    Pump Seal Plate Failuresinsight

    Water pooling under the motor instead of the pump pot typically indicates a compromised ceramic seal plate gasket.

  • 7:43

    Valve Air Leaksinsight

    Jandy or Hayward valves can develop leaks that not only lose water but also suck in air and cause the pump to lose prime.

  • 10:01

    Silicone Spray Lubricantstrategy

    Automotive RV-grade silicone spray provides superior, thorough coverage for filter tank O-rings compared to messy magic lube.

  • 12:09

    Filter Pinholesdata

    A tiny pinhole crack on a filter tank starts small but expands rapidly under high pressure and must be replaced immediately.

  • 15:59

    Temporary Backwash Fixstrategy

    Placing a simple ball valve on the backwash discharge line stops low-pressure leaks until a proper permanent repair can be made.

Quotes

  • “If you see a drip leak right by the plug, the drain plug, the winterizing plug, you can go ahead and change that O‑ring in there.”
    Unnamed speaker · 16:45
  • “A lot of times, water leaks from the old jandy never loop valves that have that kind of black knob in front. That black knob usually is broken off, and water can leak out of there.”
    Unnamed speaker · 8:06
  • “When you clean the filter, if you don’t change the O‑ring, the O‑ring is slightly stretched out, or if you don’t put enough lube on there, sometimes this will cause a drip leak.”
    Unnamed speaker · 9:40
  • Hasa 0:00–0:18
  • Skimmer 0:27–0:49
  • Pool Guy Coaching Program 1:30–1:46
  • UPA 9:04–9:23
  • Hasa 18:51–19:01
  • Skimmer 19:01–19:10

About this episode

That puddle by the equipment pad can send you down a rabbit hole fast and sometimes it is not even a pool leak. We share a simple, field-tested approach to pool leak detection that starts with one key move: turn the system off before you arrive so you can see what’s truly leaking and what’s just leftover water. We also talk about the “mystery puddle” scenario that turns out to be irrigation, and how checking sprinklers can save you a ton of time and a customer a lot of money. From there, we ...

Transcript

0:00
19:13

3,495 words · 2 speakers

Topics

  • Pentair
  • Jandy
  • Hayward
  • Autozone
  • Amazon
  • swimmingpoollearning.com

Page updated · transcript and summary are machine-generated